Post-installation instructions for XFree86[tm] on OpenBSD/i386
--------------------------------------------------------------

1. Make sure your system has support for X enabled:

You must have 'option APERTURE' in your kernel configuration and
uncomment the line that says:  

	machdep.allowaperture=1

in /etc/sysctl.conf.  See xf86(4) for more details about security
issues related to this.  After changing this variable in rc.conf, you
will need to reboot for the change to take effect.

2. Find out about your hardware:

Run SuperProbe to find out what chipset is used by your video board.
Write this information down. The `dmesg' command output is useful too.

What kind of mouse do you have, which port is it connected to?  You
may want to read /usr/X11R6/lib/X11/doc/README.mouse before going further.

3. Run XF86Setup

This will make the /etc/XF86Config file.  If for some reason XF86Setup
don't work on your hardware, try the alternate program xf86config.
See the XF86Config user's guide in /usr/X11R6/lib/X11/doc/QuickStart.doc

For manual configuration information, see XF86Config(4).

4. Start xdm, the X display manager by activating the xdm_flags option
   in /etc/rc.conf.  You do not need to disable the console getty.

5. Optionally, if you want to be able to rebuild your server from the
   XFree86 link kit, install the xlink24.tar.gz from the CD and follow
   the instructions in /usr/X11R6/lib/Server/README.

If you encounter a problem, you can browse the entire documentation 
in /usr/X11R6/lib/X11/doc or at 
http://www.xfree86.org/XFree86/3.3.6/
